Looking for Sansui Brochures, Bulletins, or Manuals? Or, need NOS parts? Visit OBS, Inc Site or Woodang.net Site
Posted by hc122 on April 16, 2004 at 19:05:45:
In Reply to: R-30 Receiver no power posted by John Appling on April 15, 2004 at 14:32:09:
: Hi,
: My R-30 receiver suddenly died. I checked the main fuse and it's OK. I'm not getting 120V to the on/off switch -HELP - Also, when I had power, my speakers would snap,crackle,pop for about 10mins then quiet down some what after that. Any suggestions on any of the above???
No power: check the components connecting to the power switch, such as fuse holder, voltage selector ( if you have one ) and check for continuity.
Snap, crackle and pop at start up happened to my Sansui 350 receiver too. I changed all the electrolytics of the amplifier section and it is cured. It can also be some small signal transistors going bad, but they normally crack all the time or got noisy.
Is the R30 a reasonable receiver to get and restored, how do you find its performance? I would like to know because I have been offer one.