Looking for Sansui Brochures, Bulletins, or Manuals (manuals include schematics)? Or, need NOS parts? Visit OBS, Inc Site, Woodang.net Site, or Go back to the Best of Sansui
Posted by Arsenio on May 26, 2004 at 11:53:25:
In Reply to: AU-919 Power Switch posted by Art Hall on May 05, 2004 at 18:12:20:
: My power switch is stuck "on" (better on than off I guess). I've tried cleaning it and got it working, but it is stuck on again. I would like to replace it if anyone know's where I can get one. I hate to buy a similar amp in the series just for switches and knobs, but I'm willing too, if that's what it takes.
: Beetle Fred, got any idea's?
: Thanks folks.
:: same with my Au-919, I did the same,but I noticed the contac points with pittings on top lever contact and bottom can be placed in reverse position from bad to good surface and soldered the incoming line to opposite terminal while the common line the same, then very slight grease on moving plastic pin and bushing not to spill on any mettelic parts perfect never stuck and nice contact.