Posted by warren on April 27, 2003 at 17:58:56:
In Reply to: Sansui AU-X901 posted by Northern Audiophile on February 28, 2003 at 18:07:46:
Your amplifier should have more then enough current to run your 2 ohms(?) speakers. I am really amazed that it can drive a 2 ohm load.
: Hello to all the International Sansui Aficionado on this web site.
: I own (along with other audio gear) a Sansui AU-X901
: From reading the information on this web site it would seem that this model was known by another designation in Japan.
: My question to the forum.
: From the specs its claimed to have 130 watts Rms into 8 ohms. However they also show Dynamic Power ratings-
: 410 watts into 2 ohms
: 390 watts into 4 ohms
: 225 watts into 8 ohms
: Can anyone tell me how to figure out the Power Output so I can know how many Amps this unit can generate.
: I ask because my speakers require a "High Current Amp".
: Any advice,information,comments welcome about this particular Sansui model. Very difficult to find any onfo on the Web.
: Au revoir