Posted by Devin A. on September 16, 2003 at 16:03:10:
In Reply to: Au-9500 woes posted by Devin B. on September 16, 2003 at 14:48:55:
Bleh, anyways I made I slight mistake, because I was running left channel only. I finally got ahold of something to test the right. It distorts VERY badly. Then pops the protection. So I need to get ahold of an oscilloscore to figure out what it is that is causing that channel to do that. If I pull the fuses going to the right channel that amp will function properly. (minus the right channel of course)
Are there any common things that may go wrong that I should check?