Posted by Warren Bendler on October 01, 2003 at 16:28:17:
In Reply to: Sansui 8080DB posted by Dave on September 30, 2003 at 00:48:27:
For the meter lamps I reccommend using high output white LEDs. You can get these from Marlin P Jones: www.mpja.com. What you do is wire 2 of them in series for each meter and use the existing 10 ohm resistor on each meter board in series with the LEDs to limit current. Install a 1N4001 diode or similar in series with the meter lamp supply, and add a 100uF/16V cap to ground on one of the meter boards. This works very well and you won't have to replace them for a very long time. For the tuning indicator I haven't found anything yet.
Warren
: I need to replace the lights in a power meter and in a tuning indicator on a Sansui 8080DB. Anyone know what the replacements are ?
: DB